Novx Products
Frequently Asked Questions

Question:

How do I "zero" the DART?

Answer:

The DART is "zeroed" by making sure the connected and operating Series 53xx has no proximity voltage in, then in the DART, install the "zero" jumper (short), then remove the jumper (open). Now if there is any offset voltage error in the Series 53xx, the correction factor (if any) is stored in non-volatile memory of the DART.

Note: When the DART is connected to a Series 300, the jumper should remain installed (shorted).

Back to Novx Product Frequently Asked Questions

 

Need help?

Contact an Application Specialist, Sales Services, or Technical Support by sending an email to MKS, Ion Systems or call 800-367-2452 or 510-217-0600.

© 2008 by MKS Instruments